AUDIO AND VISUAL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.BASIC INSPECTION |
Turn the ignition switch to ACC.
Check whether or not the radio receiver assembly turns on.
| Result | Proceed to |
| Radio receiver assembly turns on | A |
| Radio receiver assembly does not turn on | B |
|
| ||||
| |||||
| 4.CHECK FOR DTC |
Check for DTCs and note any codes that are output.
Clear the DTCs.
Recheck for DTCs by simulating the operation indicated by the DTCs.
| Result | Proceed to |
| DTC is output again | A |
| DTC is not output | B |
|
| ||||
| |||||
| 5.DIAGNOSTIC TROUBLE CODE CHART |
|
|
| 6.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING |
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|