Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › THROTTLE BODY

THROTTLE BODY > INSPECTION

for Preparation Click here



1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY


    A223680E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected:
    (Throttle with Motor Body Assembly)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (M+) - 1 (M-)
    20°C (68°F)
    0.3 to 100 Ω

    If the result is not as specified, replace the throttle with motor body assembly.