Home › ENGINE › 1GR-FE ENGINE CONTROL SYSTEM › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the service hole cover from the engine under cover.



    A070279E03
  1. Install a vinyl hose to the radiator drain cock on the radiator assembly side.
    Text in Illustration 
    *a
    Vinyl Hose
    *b
    Tape



  1. Fix the vinyl hose with tape.


    A307922E01


    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Radiator Reserve Tank Cap Sub-assembly
    *3
    Radiator Drain Cock Plug
    *4
    Cylinder Block Drain Cock Plug

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap sub-assembly and drain the engine coolant.

    HINT:
    Collect the engine coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the cylinder block drain cock plug and drain the engine coolant from the engine.

    NOTICE:
    If engine coolant is not drained from the radiator drain cock plug, cylinder block drain cock plug and radiator reservoir, clogging in the radiator assembly or engine coolant leakage from the seal of water pump may result.



2. REMOVE V-BANK COVER


    A229925E02
  1. Raise the front of the V-bank cover to disengage the 2 pins.
    Text in Illustration 
    *1
    Pin
    *2
    Hook
    *3
    No. 1 V-bank Cover Bracket

  1. Disengage the 2 hooks and remove the V-bank cover from the No. 1 V-bank cover bracket.



3. REMOVE AIR CLEANER HOSE ASSEMBLY


    A221455
  1. Loosen the hose clip and disconnect the ventilation hose from the air cleaner hose assembly.

  1. Disconnect the vacuum hose from the air cleaner hose assembly.

  1. Disengage the clamp and disconnect the wire harness from the air cleaner hose assembly.

  1. Remove the bolt and disconnect the air cleaner hose assembly from the resonator bracket.

  1. Loosen the 2 hose clamps and remove the air cleaner hose assembly from air cleaner cap sub-assembly and intake air surge tank.



4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY


    A226610
  1. Disconnect the No. 5 water by-pass hose.

  1. Disconnect the No. 4 water by-pass hose.



    A226611
  1. Disconnect the throttle body connector.

  1. Remove the 4 bolts.

  1. Remove the throttle with motor body assembly and gasket.