Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B133898E02
  1. Disengage the 2 A claws and 2 B claws.

  1. Slide the parking brake hole cover toward the front of the vehicle, disengage the 2 C claws and remove the parking brake hole cover.



2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


    B133893
  1. Remove the shift lever knob.



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


    B133895
  1. Remove the shift lever knob.



4. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B133897
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and 3 claws and remove the console upper rear panel.



5. REMOVE YAW RATE AND DECELERATION SENSOR (for Automatic Transmission)


C233010
  1. Disengage the clamp from the sensor bracket.

  1. Disconnect the yaw rate and deceleration sensor connector.

  1. Remove the 2 bolts and the yaw rate and deceleration sensor.



6. REMOVE YAW RATE AND DECELERATION SENSOR (for Manual Transmission)


C232852
  1. Disconnect the yaw rate and deceleration sensor connector.

  1. Remove the 2 bolts and the yaw rate and deceleration sensor.