Vehicle Condition
| Auto Cancel Condition
| Fail-safe Deactivation Condition
|
CRUISE main indicator light blinks
| - There is open or short in stop light switch circuit
- There is problem with vehicle speed signal
| Turn cruise control main switch on again
|
CRUISE main indicator light blinks
| - There is problem with input circuit of stop light switch circuit
- There is problem with cancel circuit
| - Turn cruise control main switch on again
- Turn engine switch off then on again
|
CRUISE main indicator light remains on (Cruise control is canceled)
| Under the following conditions, the stored vehicle speed is maintained:
- The vehicle speed is less than low speed limit (approximately 40 km/h (25 mph)) while running with cruise control on
- The VSC system is operated
| Push cruise control main switch to +RES
|
- The vehicle speed is less than the stored speed by approximately 16 km/h (10 mph) or more
| Push cruise control main switch to - SET
|
CRUISE main indicator light goes off
| There is a problem with the throttle position sensor and motor
| Turn cruise control main switch on again
|