CYLINDER HEAD > DISASSEMBLY |
| 1. REMOVE INTAKE VALVE |
![]() |
Using SST, compress the inner compression spring and remove the valve spring retainer locks.
Remove the valve spring retainer, inner compression spring and intake valve.
| 2. REMOVE EXHAUST VALVE |
![]() |
Using SST, compress the inner compression spring and remove the valve spring retainer locks.
Remove the valve spring retainer, inner compression spring and exhaust valve.
| 3. REMOVE VALVE STEM OIL SEAL |
![]() |
Using needle-nose pliers, remove the valve stem oil seals.
| 4. REMOVE VALVE SPRING SEAT |
![]() |
Using compressed air and a magnet hand, remove the valve spring seats by blowing air onto them.
| 5. REMOVE NO. 1 STRAIGHT SCREW PLUG |
![]() |
Using a 10 mm hexagon wrench, remove the 4 No. 1 straight screw plugs and 4 gaskets.
| *a | RH: |
| *b | LH: |
| 6. REMOVE NO. 2 STRAIGHT SCREW PLUG |
![]() |
Using a 14 mm hexagon wrench, remove the 2 No. 2 straight screw plugs and 2 gaskets.
| *a | RH: |
| *b | LH: |
| 7. REMOVE STUD BOLT |