Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SEAT POSITION SENSOR

SEAT POSITION SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



3. REMOVE FRONT SEAT ASSEMBLY LH


    B135117E01
  1. for Driver Side:

    1. Using a clip remover, remove the clamp.

    2. Disconnect the 2 buckle switch connectors.

    3. Slide the slider and disconnect the airbag connector.



    B135119E01
  1. for Front Passenger Side:

    1. Using a clip remover, remove the clamp.

    2. Disconnect the connector.

    3. Slide the slider and disconnect the airbag connector.



    B130665
  1. Move the front seat to the most forward position.

  1. Remove the 2 bolts from the rear side.

  1. Move the front seat to the most rearward position.

  1. Remove the 2 bolts from the front side.

  1. Remove the front seat.



4. REMOVE SEAT POSITION SENSOR
  1. Disconnect the connector from the seat position sensor.



    C128270
  1. Remove the bolt and the seat position sensor.