Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures described below are for the LH side.



1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



3. REMOVE FRONT DOOR SCUFF PLATE LH


    B130597
  1. Disengage the 14 claws and remove the front door scuff plate.



4. REMOVE ACCESS DOOR SCUFF PLATE LH


    B130598
  1. Disengage the 6 claws and remove the access door scuff plate.



5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
  1. Remove the front door opening trim weatherstrip LH to the extent necessary to remove the side airbag sensor LH .



6. REMOVE SIDE AIRBAG SENSOR LH


    C128263E01
  1. Disconnect the connector from the side airbag sensor LH.



    C128265
  1. Remove the bolt and the side airbag sensor LH.