Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT AIRBAG SENSOR

FRONT AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures described below are for the LH side.



1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



3. REMOVE RADIATOR GRILLE


    B134729
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 screws.

  1. Disengage the 5 clips and remove the radiator grille.



4. REMOVE FRONT BUMPER COVER


    B134730E02
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape



    B138606
  1. Using a clip remover, remove the 5 clips.



    B134731
  1. Remove the 8 screws and the 4 bolts.



    B134733
  1. Disengage the 2 claws and remove the front bumper cover.



    B138601
  1. Remove the 4 clips.



5. REMOVE FRONT AIRBAG SENSOR LH


    C128245
  1. Remove the 2 bolts.

  1. Disengage the 2 claws and the front airbag sensor LH.



    C128261E01
  1. Disconnect the connector from the front airbag sensor LH.