Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > INSPECTION

for Preparation Click here



1. INSPECT FRONT WIPER MOTOR


    E104082E04
  1. Check the LO operation.

    1. Connect the positive battery (+) lead to terminal 1 (+1) of the connector and the negative battery (-) lead to terminal 5 (E), then check that the motor operates at low speed (LO).

      Standard:
      Motor operates at low speed (LO).

      If the result is not as specified, replace the motor.

  1. Check the HI operation.

    1. Connect the positive battery (+) lead to terminal 4 (+2) of the connector and the negative battery (-) lead to terminal 5 (E), then check that the motor operates at high speed (HI).

      Standard:
      Motor operates at high speed (HI).

      If the result is not as specified, replace the motor.



  1. Check the automatic stop operation.

    1. Connect the positive battery (+) lead to terminal 1 (+1) of the connector and the negative battery (-) lead to terminal 5 (E). With the motor operating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

    2. Using SST, connect terminals 3 (S) and 1 (+1). Connect the positive battery (+) lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

      SST
      09843-18040  



    3. E127870E01
    4. Check that the motor stops automatically in the automatic stop position.

      Standard:
      Refer to the illustration.

      If the result is not as specified, replace the motor.