MULTIPLEX COMMUNICATION SYSTEM > SYSTEM DESCRIPTION |
| MULTIPLEX COMMUNICATION SYSTEM (BEAN) |
The BEAN communication line consists of 2 systems: One is a system with a loop-shaped line that links the back door ECU with the main body ECU, which is located in the center of the line.
Since the line for the back door ECU is loop-shaped, communication can be maintained by the line that is not open even if part of the line becomes open for some reason. In the case that there is a short-circuit (bus-down) in the line, however, all the BEAN communication becomes impossible in the system and some DTCs are output.
| CHECK COMMUNICATION FUNCTION |
Check the battery voltage.
Inspect the DTC output.
Check for DTCs concerning the main body ECU by connecting the Techstream to the DLC3 and turning the ignition switch ON.
When the display shows DTCs concerning the ECU being unconnected and the communication bus defective, perform the inspection depending on the troubleshooting procedures.