Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

MULTIPLEX COMMUNICATION SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
  1. The main body ECU controls the functions of the multiplex communication system on the vehicle. Data of the multiplex communication system and the Diagnostic Trouble Codes (DTC) can be read through the Data Link Connector 3 (DLC3) of the vehicle.


CHECK DLC3


    H100769E16
  1. The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.

    Symbols (Terminal No.)
    Terminal Description
    Condition
    Specified Condition
    7 (SIL) - 5 (SG)
    Bus "+" line
    During transmission
    Pulse generation
    4 (CG) - Body ground
    Chassis ground
    Always
    Below 1 Ω
    5 (SG) - Body ground
    Signal ground
    Always
    Below 1 Ω
    16 (BAT) - Body ground
    Battery positive
    Always
    11 to 14 V
    6 (CANH) - 14 (CANL)
    HIGH-level CAN bus line
    Ignition switch OFF*
    54 to 69 Ω
    6 (CANH) - 4 (CG)
    HIGH-level CAN bus line
    Ignition switch OFF*
    200 Ω or more
    14 (CANL) - 4 (CG)
    LOW-level CAN bus line
    Ignition switch OFF*
    200 Ω or more
    6 (CANH) - 16 (BAT)
    HIGH-level CAN bus line
    Ignition switch OFF*
    6 kΩ or more
    14 (CANL) - 16 (BAT)
    LOW-level CAN bus line
    Ignition switch OFF*
    6 kΩ or more

    CAUTION:
    *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors.

    1. If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

  2. Techstream

    HINT:
    Connect the cable of the Techstream to the CAN VIM, connect the CAN VIM to the DLC3, turn the ignition switch ON and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
    1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
    2. If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.


INSPECT BATTERY VOLTAGE
If the voltage is below 11 V, recharge or replace the battery before proceeding.

Standard voltage:
11 to 14 V