DTC B1214 Short to B+ in Door System Communication Bus Malfunction |
DTC B1215 Short to GND in Door System Communication Bus Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1214 | Communication circuit and +B battery system short |
|
| B1215 | Door system communication circuit and body ground short |
|

| 1.CHECK DIAGNOSTIC TROUBLE CODE (BACK DOOR ECU) |
Disconnect the back door ECU connector and check for DTCs B1214 and B1215.

|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BACK DOOR ECU) |
Check for a short-circuit in B+ or body ground.

![]() |
Disconnect the S2 back door ECU connector and E6 main body ECU connector.
Measure the voltage between the terminals of the S2 back door ECU or E6 main body ECU connector and body ground.
| Tester Connection | Condition | Specified Condition |
| E6-23 (MPX2) or S2-1 (MPX2) - Body ground | Ignition switch ON | Below 1 V |
Check the resistance.
| Tester Connection | Specified Condition |
| E6-23 (MPX2) or S2-1 (MPX2) - Body ground | 10 kΩ or higher |
Reconnect the back door ECU connector and main body ECU connector.
|
| ||||
| OK | ||
| ||