Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here


HINT:
By accessing the DATA LIST displayed on the Techstream, values of switches and sensors can be read without removing any parts. Reading the DATA LIST is the first step of troubleshooting and is one method shortening diagnostic time.


DATA LIST FOR CENTER AIRBAG SENSOR ASSEMBLY
  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the Techstream to the DLC3.

  4. Turn the ignition switch to ON.

  5. Turn the tester on.

  6. Enter the following menus: Body Electrical / SRS Airbag / Data List /

  7. According to the display on tester, read the "Data List".

    SRS Airbag: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Driver Seat Position
    Seat position (Driver side)/
    Forward: Seat position is forward
    Bkward: Seat position is backward
    FAIL: Failure detected
    Forward/Bkward
    -
    Passenger Classification
    Front passenger classification/
    NG: Data is not determined
    OFF: Vacant
    Child: Child (Less than 36 kg [79.37 lb]) is seated
    AF05: Adult (36 to 54 kg [79.37 to 119.05 lb]) is seated
    AM50: Adult (More than 54 kg [119.05 lb]) is seated
    Fail: A failure is detected
    NG/OFF/Child/AF05/AM50/Fail
    -
    Drive Buckle SW
    Driver seat belt buckle switch/
    Unset: The seat belt is not fastened
    Set: The seat belt is fastened
    NG: Data is not determined
    Unset/Set
    -
    Passenger Buckle SW
    Passenger seat belt buckle switch/
    Unset: The seat belt is not fastened
    Set: The seat belt is fastened
    NG: Data is not determined
    Unset/Set
    -
    Display Type Information
    Display type identification information/
    LR: Display indicated by LH/RH
    DP: Display indicated by Driver/Passenger
    DP
    -
    Number of Past DTC
    Number of past DTCs/
    Min.: 0, Max.: 255
    0
    -