Home › ENGINE › 1GR-FE FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY
  1. Check that the float moves smoothly between F (Upper End) and E (Lower End).



    A307918E01
  1. Check the resistance.
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Sender Gauge Assembly)
    *b
    F (Upper End)
    *c
    E (Lower End)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      F (Upper End)
      13.5 to 16.5 Ω
      Between F (Upper End) - E (Lower End)
      13.5 to 414.5 Ω
      (Gradually changes)
      E (Lower End)
      405.5 to 414.5 Ω

      If the result is not as specified, replace the fuel sender gauge assembly.