Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT YAW RATE AND DECELERATION SENSOR
  1. Check the yaw rate and deceleration sensor.
    If any of the following occurs, replace the yaw rate and deceleration sensor with a new one.

    1. The surface of the yaw rate and deceleration sensor is cracked, dented or chipped.
    2. The connector is scratched, cracked, or damaged.
    3. The yaw rate and deceleration sensor has been dropped.