Home › DRIVE LINE ยท DIFFERENTIAL › DIFFERENTIAL OIL

DIFFERENTIAL OIL > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK DIFFERENTIAL OIL


D025304E05
  1. Stop the vehicle on a level surface.

  1. Remove the differential filler plug and gasket.

  1. Check that the oil level is between 0 to 5 mm (0 to 0.20 in.) from the bottom lip of the differential filler plug hole.

    NOTICE:
    1. After changing the oil seal, drive the vehicle and then check the oil level again.
    1. Too much or too little oil will lead to differential problems.

    HINT:
    If necessary, fill the differential carrier assembly with hypoid gear oil.

    Differential oil type and viscosity:
    Toyota Genuine Differential gear oil LT 75W-85 API GL-5 SAE 75W-85 or equivalent


    Differential Oil Capacity:

    Item
    Capacity
    Front Differential
    w/o A.D.D.
    1.35 to 1.45 Liters
    (1.43 to 1.53 US qts, 1.19 to 1.28 Imp qts.)
    w/ A.D.D.
    1.50 to 1.60 Liters
    (1.59 to 1.69 US qts, 1.32 to 1.41 Imp qts.)
    Rear Differential
    w/o Differential Lock
    2.45 to 2.55 Liters
    (2.59 to 2.69 US qts, 2.16 to 2.24 Imp qts.)
    w/ Differential Lock
    2.40 to 2.50 Liters
    (2.54 to 2.64 US qts, 2.11 to 2.20 Imp qts.)

  1. Check for oil leakage when the oil level is low.

  1. Install the differential filler plug with a new gasket.

    Torque:
    Front differential:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }
    Rear differential:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }