Home › DRIVE LINE ยท DIFFERENTIAL › FRONT DIFFERENTIAL CARRIER ASSEMBLY

FRONT DIFFERENTIAL CARRIER ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT WHEEL


3. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY


4. REMOVE REAR ENGINE UNDER COVER ASSEMBLY


5. DRAIN DIFFERENTIAL OIL


6. REMOVE FRONT PROPELLER SHAFT ASSEMBLY


C098708E04
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4bolts and 4 washers.



    C098709E03
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts, 4 washers and the propeller shaft assembly.



7. SEPARATE SPEED SENSOR FRONT LH


C235318
  1. Remove the bolt and separate the front speed sensor.

  1. Disengage the clamp.

  1. Remove the 2 bolts and separate the skid control sensor wire from the steering knuckle.



8. SEPARATE FRONT SPEED SENSOR RH

HINT:
Use the same procedure as for the RH side.



9. REMOVE FRONT AXLE HUB GREASE CAP LH


F042729
  1. Using a screwdriver and a hammer, remove the front axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.



10. REMOVE FRONT AXLE HUB GREASE CAP RH

HINT:
Use the same procedure as for the RH side.



11. SEPARATE TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and nut.



    F051679E01
  1. Using SST, separate the tie rod end from the steering knuckle.

    SST
    09628-62011  



12. SEPARATE TIE ROD END SUB-ASSEMBLY RH


13. SEPARATE FRONT LOWER BALL JOINT ATTACHMENT


G020159
  1. Remove the 2 bolts and separate the front lower ball joint attachment from the steering knuckle.



14. REMOVE FRONT AXLE HUB NUT LH


F042732
  1. Remove the cotter pin and adjusting lock cap.

  1. Remove the front axle hub nut.



15. REMOVE FRONT AXLE HUB NUT RH

HINT:
Use the same procedure as for the RH side.



16. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH


F042739E01
  1. Using SST, remove the front drive shaft.

    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    Do not damage the oil seal.



17. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

HINT:
Use the same procedure as for the RH side.



18. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY


C097020E01
  1. Remove the bolt and disconnect the differential breather tube bracket.

  1. Support the differential with a jack.

  1. Remove the No. 1 differential mounting nut.

  1. Remove the 2 mounting bolts and 2 nuts.

  1. Lower the jack and remove the front differential.



    B084273E02
  1. Remove the 3 bolts and front No. 1 differential support.



    B084274E01
  1. Remove the 2 bolts and front No. 2 differential support.



    B084275E01
  1. Remove the 2 bolts and front No. 3 differential support.