Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY


G034253E01
  1. Install the park/neutral position switch onto the manual valve shaft.

  1. Temporarily install the bolt.

  1. Install a new lock washer and the nut.

    Torque:
    6.9 N*m{ 70 kgf*cm , 61 in.*lbf }



    D028682E01
  1. Push the control shaft rearward as much as possible.

  1. Return the control shaft lever 2 notches to the N position.



    D025795E07
  1. Align the neutral basic line with the switch groove, and tighten the bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Using a screwdriver, bend the tabs of the lock washer.



2. CONNECT PARK / NEUTRAL POSITION SWITCH CONNECTOR


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



4. PERFORM INITIALIZATION
(Click here)


5. INSPECT SHIFT LEVER POSITION
  1. Check that the shift lever moves smoothly and appropriately from the P to the R position, only when the ignition switch is turned to ON and the brake pedal is depressed.

  1. When starting the engine, make sure that the vehicle moves forward when shifting the lever from the N to the D position and moves rearward when shifting the lever to the R position.



6. ADJUST SHIFT LEVER POSITION


    D028682E07
  1. Push the control shaft fully rearward.
    Text in Illustration 
    *a
    N Position

  1. Turn the control shaft lever 2 notches counterclockwise to the N position.

  1. Set the shift lever to the N position.



7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Apply the parking brake and turn the ignition switch ON.

  1. Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start in other positions.

  1. Check that the back-up light illuminates and the reverse warning buzzer sounds when the shift lever is in R, but not in other positions.