Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR


3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


G034253E01
  1. Using a screwdriver, pry out the lock washer.

  1. Remove the lock nut and the lock washer.

  1. Remove the bolt and the park/neutral position switch assembly.

    HINT:
    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.