OCCUPANT CLASSIFICATION SYSTEM > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
![]() |
The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus " + " line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | HIGH- level CAN bus line | Ignition switch OFF*
| 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH- level CAN bus line | Ignition switch OFF*
| 200 Ω or higher |
| CANL (14) - CG (4) | LOW- level CAN bus line | Ignition switch OFF*
| 200 Ω or higher |
| CANH (6) - BAT (16) | HIGH- level CAN bus line | Ignition switch OFF*
| 6 kΩ or higher |
| CANL (14) - BAT (16) | LOW- level CAN bus line | Ignition switch OFF*
| 6 kΩ or higher |
| SYMPTOM SIMULATION |
![]() |
Vibration method: When vibration seems to be the major cause.
Slightly vibrate the part of the sensor considered to be the cause of the problem with your fingers and check whether the malfunction occurs.
Slightly shake the connector vertically and horizontally.
Slightly shake the wire harness vertically and horizontally.
The connector joint and fulcrum of the vibration are the major areas to be checked thoroughly.
Simulation method for DTC B1795: Turn the ignition switch from the lock to the on position, hold for 10 seconds, and then back to the lock position again 50 times in a row.
| FUNCTION OF PASSENGER AIRBAG ON/OFF INDICATOR |
Initial check
Turn the ignition switch to the on position.
The passenger airbag ON/OFF indicator (ON and OFF) comes on for approximately 4 seconds, then goes off for approximately 2 seconds.
Approximately 6 seconds after the ignition switch is turned to the on position, the passenger airbag ON/OFF indicator will be ON/OFF depending on the conditions listed below.
| Condition | ON Indicator | OFF Indicator |
| Vacant | OFF | OFF |
| Adult is seated | ON | OFF |
| Child is seated | OFF | ON |
| Child restraint system is set | OFF | ON |
| Front passenger occupant classification system failure | OFF | ON |

| PASSENGER AIRBAG ON/OFF INDICATOR CHECK |
![]() |
Turn the ignition switch to the on position.
Check that the passenger airbag ON/OFF indicator (ON and OFF) comes on for approximately 4 seconds, then goes off for approximately 2 seconds.