Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › OCCUPANT CLASSIFICATION SYSTEM

OCCUPANT CLASSIFICATION SYSTEM > INITIALIZATION

for Preparation Click here



ZERO POINT CALIBRATION

NOTICE:
Make sure that the front passenger seat is not occupied before performing the operation.

HINT:
Perform the zero point calibration and sensitivity check if any of the following conditions apply.
  1. The occupant classification ECU is replaced.
  2. Accessories (seatback tray and seat cover, etc.) are installed.
  3. The front passenger seat is removed from the vehicle.
  4. The passenger airbag ON/OFF indicator (OFF) comes on when the front passenger seat is not occupied.
  5. The vehicle is brought to the workshop for repair due to an accident or a collision.

  1. Zero point calibration and sensitivity check procedures

    HINT:
    Make sure that the zero point calibration is finished normally, and then perform the sensitivity check.


    1. Adjust the seat position in accordance with the table below.
      Adjustment Item
      Position
      Slide Direction
      Rearmost position
      Reclining Angle
      Upright position
      Headrest Height
      Lowest position
      Lifter Height
      Lowest position

    2. Connect a Techstream to the DLC3.

    3. Turn the ignition switch to the on position.

    4. Perform the zero point calibration by following the prompts on the tester screen.

      HINT:
      Refer to the Techstream operator's manual for further details.

      OK:
      COMPLETED is displayed.

    5. Perform the sensitivity check by following the prompts on the tester screen.

    6. Confirm that the beginning sensor reading is within the standard range.

      Standard range:
      -3.2 to 3.2 kg (-7 to 7 lb)

    7. Place a 30 kg (66.14 lb) weight (e.g. a lead mass) onto the front passenger seat.

    8. Confirm that the sensitivity is within the standard range.

      Standard range:
      27 to 33 kg (59.52 to 72.75 lb)

      HINT:
      1. When performing the sensitivity check, use a solid metal weight (the check result may not be accurate if a liquid weight is used).
      2. If the sensitivity deviates from the standard range, retighten the bolts of the front passenger seat taking care not to deform the seat rail. After performing this procedure, if the sensitivity is not within the standard range, replace the front seat adjuster sub-assembly RH.
      3. If the zero point calibration has not finished normally, replace the front seat adjuster sub-assembly RH.