Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

B294021E01

  1. Disconnect the H7 power window regulator master switch assembly connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    H7-15 (B) - Body ground
    W - Body ground
    Ignition power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    H7-7 (E) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the H7 power window regulator master switch assembly connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    H7-10 (U) - H7-7 (E)
    L - W-B
    Power window motor UP output
    Ignition switch ON, driver side power window switch OFF → UP (manual operation)
    Below 1 V → 11 to 14 V
    H7-12 (D) - H7-7 (E)
    L-B - W-B
    Power window motor DOWN output
    Ignition switch ON, driver side power window switch OFF → DOWN (manual operation)
    Below 1 V → 11 to 14 V
    Ignition switch ON, driver side power window fully closed → driver side power window switch DOWN (AUTO operation) → driver side power window fully open
    Below 1 V → 11 to 14 V → Below 1 V
    If the result is not as specified, the master switch may have a malfunction.

  5. Check the AUTO light illumination.

    1. After turning the ignition switch ON, check that the AUTO light illuminates (amber).


CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY

B294022E01

  1. Disconnect the G6 power window regulator switch assembly connector.

  2. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G6-3 (B) - Body ground
    W - Body ground
    Ignition power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    G6-1 (D) - Body ground
    L-B - Body ground
    Power window motor DOWN output
    Ignition switch ON, power window switch OFF → DOWN
    Below 1 V → 11 to 14 V
    G6-2 (SD) - Body ground
    R - Body ground
    Power window motor DOWN input (Remote)
    Ignition switch ON, power window master switch OFF → DOWN (Remote)
    Below 1 V → 11 to 14 V
    G6-4 (U) - Body ground
    L - Body ground
    Power window motor UP output
    Ignition switch ON, power window switch OFF → UP
    Below 1 V → 11 to 14 V
    G6-5 (SU) - Body ground
    R-B - Body ground
    Power window motor UP input (Remote)
    Ignition switch ON, power window master switch OFF → UP (Remote)
    Below 1 V → 11 to 14 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the G6 power window regulator switch assembly connector.