KEY REMINDER WARNING SYSTEM > TERMINALS OF ECU |
| CHECK COMBINATION METER ASSEMBLY |

Using the tester probes, touch the terminals from the back of the vehicle wire harness connectors, and measure the voltages and resistances.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| E13-2 (IG+) - Body ground | R-L - Body ground | Ignition switch signal | Ignition switch OFF → ON | Below 1 V → 11 to 14 V |
| E13-1 (B) - Body ground | R - Body ground | Battery | Always | 11 to 14 V |
| E13-9 (KSW) - Body ground | V-G - Body ground | Key unlock warning switch signal input | Key inserted → Key removed from ignition key cylinder | Below 1 V → 10 to 14 V |
| E13-29 (DOOR) - Body ground | W-L - Body ground | Driver door courtesy switch signal input | Driver door closed → open | Below 1 V → 11 to 14 V |
| E13-21 (ES) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| CHECK MAIN BODY ECU |


Using the tester probes, touch the terminals from the back of the vehicle wire harness connectors, and measure the voltages.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| E8-14 (KSW) - Body ground | G-Y - Body ground | Key unlock warning switch input | Key inserted → Key removed from ignition key cylinder | Below 1 V → to 14 V |
| 1H-2 (GND1) - Body ground | W-B - Body ground | Ground | Always | Below 1 V |
| 1B-4 (BECU) - Body ground | W-R - Body ground | Battery | Always | to 14 V |
| E7-23 (DCTY) - Body ground | R-B - Body ground | Driver door courtesy switch input | Driver door closed → open | to 14 V → Below 1 V |
| E8-15 (KSWO) - Body ground | V-G - Body ground | Key unlock warning switch signal output | Key inserted → Key removed from ignition key cylinder | Below 1 V → to 14 V |
| E8-11 (DCY2) - Body ground | W-L - Body ground | Driver door courtesy switch signal output | Driver door closed → open | 10 to 14 V → Below 1 V |