Start the engine.
- HINT:
- When the initial circling calibration has not yet been performed, the COMPASS indicator in the outside temperature display blinks.
Switch the mode to compass correction mode by pushing the SET button for about 2 seconds, until a number appears in the outside temperature display.
- HINT:
- If no button operations occur for more than 6 seconds while in compass correction mode, calibration is cancelled and the display returns to the outside temperature indication. To restart, perform the procedure from the first step again.
Push the SET button again to change the mode to turn correction mode.
- HINT:
- While in correction mode, the indication bars move as shown in the illustration.

|
If there is sufficient space to drive the vehicle in a circle, perform the following procedure:
- Drive the vehicle in a full circle within 2 minutes, at a vehicle speed of 5 mph (8 km/h) or lower, as shown in the illustration.
- NOTICE:
- Do not perform the circling calibration of the compass in a place where the earth's magnetic field is subject to interference by artificial magnetic fields (underground parking, under a steel tower, between buildings, roof parking, near a crossing, near a large vehicle, etc.).
- During the calibration, do not operate any electric systems (power window, etc.) as they may interfere with the calibration.
- HINT:
- When the compass display returns to the outside temperature display, the calibration is complete.
- When the circling calibration fails, "Er" is displayed for about 2 seconds and then the COMPASS indicator flashes.
- If the correct direction is not displayed after driving the vehicle as specified, change the vehicle location.
- To cancel the calibration before completion, push the SET button for about 2 seconds.

|
If enough space is not available to drive in a circle, perform the following:
- Perform a four-point turn within 2 minutes, as shown in the illustration.
- NOTICE:
- Do not perform the circling calibration of the compass in a place where the earth's magnetic field is subject to interference by artificial magnetic fields (underground parking, under a steel tower, between buildings, roof parking, near a crossing, near a large vehicle, etc.).
- During the calibration, do not operate any electric systems (power window, etc.) as they may interfere with the calibration.
- HINT:
- When the compass display returns to the outside temperature display, the calibration is complete.
- When the circling calibration fails, "Er" is displayed for about 2 seconds and then the COMPASS indicator flashes.
- If the correct direction is not displayed after driving the vehicle as specified, change the vehicle location.
- To cancel the calibration before completion, push the SET button for about 2 seconds.
Check that the COMPASS indicator is not blinking and that the compass is displayed normally.