Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM


E219926E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuse for circuits related to this system before performing the following inspection procedure.

1.INSPECT HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)


    E219927E02
  1. Disconnect the E83*1 or E41*2 radio receiver assembly connector.
    *1: for 10 Speaker with Sub-woofer
    *2: for 6 Speaker

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (for 10 Speaker with Sub-woofer):
    Tester Connection
    Condition
    Specified Condition
    E83-20 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Resistance (for 6 Speaker):
    Tester Connection
    Condition
    Specified Condition
    E41-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage (for 10 Speaker with Sub-woofer):
    Tester Connection
    Switch Condition
    Specified Condition
    E83-1 (B) - E83-20 (GND)
    Always
    11 to 14 V
    E83-11 (ACC) - E83-20 (GND)
    Ignition switch ACC
    11 to 14 V

    Standard Voltage (for 6 Speaker):
    Tester Connection
    Switch Condition
    Specified Condition
    E41-4 (B) - E41-7 (GND)
    Always
    11 to 14 V
    E41-3 (ACC) - E41-7 (GND)
    Ignition switch ACC
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Radio Receiver Assembly (for 10 Speaker with Sub-woofer))
    *b
    Front view of wire harness connector
    (to Radio Receiver Assembly (for 6 Speaker))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)