Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the stereo component amplifier assembly.

WIRING DIAGRAM


E219928E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.INSPECT HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - BATTERY AND GROUND)


    E219929E02
  1. Disconnect the K10 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K10-1 (GND) - Body ground
    Always
    Below 1 Ω
    K10-11 (GND2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K10-10 (+B) - K10-1 (GND)
    Always
    11 to 14 V
    K10-20 (+B2) - K10-1 (GND)
    Always
    11 to 14 V
    K10-18 (ACC) - K10-1 (GND)
    Ignition switch ACC
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Stereo Component Amplifier Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)