Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > TERMINALS OF ECU

for Preparation Click here



CLEARANCE WARNING ECU

E149991E18

  1. Disconnect the E80 clearance warning ECU connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E80-10 (IG) - Body ground
    LG - Body ground
    Clearance sonar main switch signal
    Ignition switch ON, back sonar switch ON
    11 to 14 V
    Ignition switch ON, back sonar switch OFF
    Below 1.5 V
    E80-21 (E) - Body ground
    W-B - Body ground
    Body ground
    Always
    Below 1 Ω
    E80-21 (E) - E80-22 (E2)
    W-B - W
    Ground for ultrasonic sensor
    Always
    Below 1 Ω

  3. Reconnect the clearance warning ECU connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E80-3 (SPD) - Body ground
    V-R - Body ground
    Vehicle speed signal
    Ignition switch ON, turn drive wheels slowly
    Pulse generation
    E80-6 (SOR) - E80-21 (E)
    B - W-B
    Rear sensor communication signal
    Ignition switch ON, back sonar switch ON
    Pulse generation
    (See waveform 1)
    E80-12 (BBZ) - E80-21 (E)
    L-B - W-B
    Clearance warning buzzer signal
    Buzzer sounding
    Pulse generation
    (See waveform 2)
    E80-13 (RL) - E80-21 (E)
    R-Y - W-B
    Reverse position signal
    Ignition switch ON, shift lever not in R
    Below 1.5 V
    Ignition switch ON, shift lever in R
    7 V or higher
    E80-24 (BOR) - E80-21 (E)
    R-L - W-B
    Power source for rear sensor circuit
    Ignition switch off
    Below 1.5 V
    Ignition switch ON
    7.2 to 8.8 V



  5. Using an oscilloscope, check waveform.



      E159890E01
    1. Waveform 1
      Terminal Connection
      E80-6 (SOR) - E80-21 (E)
      Tester Range
      2 V/DIV., 200 μsec./DIV.
      Vehicle Condition
      Ignition switch ON, back sonar switch ON



    2. E160786E01
    3. Waveform 2
      Terminal Connection
      E80-12 (BBZ) - E80-21 (E)
      Tester Range
      2 V/DIV., 200 μsec./DIV.
      Vehicle Condition
      Buzzer sounding