Home › BODY ELECTRICAL › OTHER SYSTEM › CLOCK SYSTEM

CLOCK SYSTEM > TERMINALS OF ECU

for Preparation Click here



CLOCK ASSEMBLY

B133351E01

  1. Disconnect the clock assembly connector.

  2. Measure the voltage of the wire harness side connector.

    Standard voltage: 
    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    F2-3 (ILL+) - Body ground
    G - Body ground
    Illumination Signal
    Combination switch OFF
    Below 1 V
    Combination switch Head
    11 to 14 V
    F2-4 (ACC) - Body ground
    GR - Body ground
    Ignition Switch Signal
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    11 to 14 V
    F2-2 (E) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 V
    F2-1 (B) - Body ground
    R - Body ground
    Battery
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction on the wire harness side.