Home › BODY › WINDSHIELD / WINDOWGLASS › GLASS HATCH OPENER SYSTEM

GLASS HATCH OPENER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK BACK DOOR ECU

B062706E02

  1. Measure the voltages of the wire harness side connectors.

    Standard voltage: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    BECU (S2-5) - GND (S2-3)
    W-R - W-B
    ECU power supply (from battery)
    Always
    11 to 14 V
    GND (S2-3) - Body ground
    W-B - Body ground
    Ground circuit
    Always
    Below 1 V
    L (S5-5) - E (S5-19)
    L - V-G
    Back door lock key cylinder lock signal (Back window unlock signal)
    Back door lock key cylinder lock OFF
    11 to 14 V
    Back door lock key cylinder lock ON (LOCK)
    Below 1 V
    GHC+ (S5-13) - GND (S2-3)
    L-Y - W-B
    Back window unlock operation signal
    Back door lock key cylinder lock OFF
    Below 1 V
    Back door lock key cylinder lock ON (LOCK) for 0.8 seconds or more
    11 to 14 V → Below 1 V
    P (S5-12) - E (S5-19)
    P-B - V-G
    Rear wiper housing position switch signal
    Ignition switch ON and wiper switch OFF
    Below 1 V
    If the result is not as specified, there may be a malfunction on the wire harness side.