WIRELESS DOOR LOCK CONTROL SYSTEM > DTC CHECK / CLEAR |
| SELF-DIAGNOSTIC MODE (OPERATING IGNITION KEY CYLINDER) |
Switch to self-diagnostic mode.
Establish the vehicle's initial condition.
Insert the key into the ignition key cylinder and remove it.
Within 5 seconds of removing the key, insert it into the ignition key cylinder again.
Turn the ignition switch ON and then OFF.
Within 30 seconds of turning the ignition switch OFF, perform the following operation 9 more times: Turn the ignition switch to ON and then OFF.
![]() |
Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer sound.
Check the diagnostic outputs when the door control transmitter switch is held down. The diagnostic outputs can be checked by the wireless door lock buzzer sound.
