Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › OCCUPANT CLASSIFICATION ECU

OCCUPANT CLASSIFICATION ECU > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



3. REMOVE FRONT SEAT ASSEMBLY RH


    B135117E01
  1. for Driver Side:

    1. Using a clip remover, remove the clamp.

    2. Disconnect the 2 buckle switch connectors.

    3. Slide the slider and disconnect the airbag connector.



    B135119E01
  1. for Front Passenger Side:

    1. Using a clip remover, remove the clamp.

    2. Disconnect the connector.

    3. Slide the slider and disconnect the airbag connector.



    B130665
  1. Move the front seat to the most forward position.

  1. Remove the 2 bolts from the rear side.

  1. Move the front seat to the most rearward position.

  1. Remove the 2 bolts from the front side.

  1. Remove the front seat.



4. REMOVE OCCUPANT CLASSIFICATION ECU
  1. Disconnect the 2 connectors from the occupant classification ECU.



    C128253
  1. Using a screwdriver, remove the occupant classification ECU.