Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › TRANSMISSION WIRE

TRANSMISSION WIRE > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION WIRE


C113707
  1. Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the transmission wire connector.



2. CONNECT TRANSMISSION WIRE


D012704E03
  1. Connect the 7 connectors to the solenoid valves.

  1. Install the 2 clamps with the 2 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf } for bolt A
    11 N*m{ 112 kgf*cm , 8 ft.*lbf } for bolt B

    Bolt length:
    12 mm (0.47 in.) for bolt A
    36 mm (1.42 in.) for bolt B

  1. Connect the ATF temperature sensor.



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


D028692E01
  1. Install a new O-ring and oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


F051848E01

HINT:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install the oil pan with the 20 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



6. PERFORM INITIALIZATION
(Click here)


7. ADJUST AUTOMATIC TRANSMISSION FLUID
(Click here)