EXTENSION HOUSING REAR OIL SEAL > INSTALLATION |
| 1. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL |
![]() |
Coat the lip of the oil seal with MP grease.
Using SST and a hammer, carefully tap in a new oil seal in as far as possible.
| 2. INSTALL PROPELLER SHAFT ASSEMBLY |
![]() |
Remove SST from the extension housing.
Install the propeller shaft assembly into the extension housing.
![]() |
Align the matchmarks on the propeller shaft flange and differential flange.
Install the propeller shaft assembly with the 4 bolts, 4 nuts and 4 washers.
| 3. ADJUST AUTOMATIC TRANSMISSION FLUID |