EXTENSION HOUSING REAR OIL SEAL > REMOVAL |
| 1. REMOVE PROPELLER SHAFT ASSEMBLY |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts, 4 bolts and 4 washers.
Remove the propeller shaft assembly.
![]() |
Insert SST into the extension housing to prevent oil leakage.
| 2. DRAIN AUTOMATIC TRANSMISSION FLUID |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 3. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL |
![]() |
Using SST, remove the oil seal.