Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › OIL PUMP

OIL PUMP > INSPECTION

for Preparation Click here



1. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY


D027954E01
  1. Using a dial indicator, measure the inside diameter of the oil pump body bushing.

    Maximum inside diameter:
    38.188 mm (1.504 in.)

    1. If the inside diameter is greater than the maximum, replace the oil pump body.



2. INSPECT STATOR SHAFT ASSEMBLY


D027955E01
  1. Using a dial indicator, measure the inside diameter of the stator shaft bushing.

    Maximum inside diameter:
    Front side:
    21.577 mm (0.850 in.)
    Rear side:
    32.08 mm (1.263 in.)

    1. If the inside diameter is grater than the maximum, replace the stator shaft.



3. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY


D027956E01
  1. Push the driven gear to one side of the body.

  1. Using a feeler gauge, measure the clearance.

    Standard body clearance:
    0.10 to 0.17 mm (0.0039 to 0.0067 in.)

    Maximum body clearance:
    0.17 mm (0.0067 in.)

    1. If the body clearance is greater than the maximum, replace drive gear, the driven gear or pump body.



    D027957E01
  1. Using a feeler gauge, measure the clearance between the driven gear teeth and drive gear teeth.

    Standard tip clearance:
    0.07 to 0.15 mm (0.0028 to 0.0059 in.)

    Maximum tip clearance:
    0.15 mm (0.0059 in.)

    1. If the tip clearance is greater than the maximum, replace drive gear, the driven gear or pump body.



    D001286E01
  1. Using a steel straight edge and feeler gauge, measure the side clearance of both gears.

    Standard side clearance:
    0.02 to 0.05 mm (0.0008 to 0.0020 in.)

    Maximum side clearance:
    0.05 mm (0.0020 in.)

  1. There are 5 different thicknesses for the drive and driven gears.

    Drive and drive gears thickness:
    Mark
    Thickness
    0
    10.740 to 10.749 mm (0.4228 to 0.4232 in.)
    1
    10.750 to 10.759 mm (0.4232 to 0.4236 in.)
    2
    10.760 to 10.769 mm (0.4236 to 0.4240 in.)
    3
    10.770 to 10.779 mm (0.4240 to 0.4244 in.)
    4
    10.780 to 10.789 mm (0.4244 to 0.4248 in.)

    1. If the side clearance is greater than the maximum, replace drive gear, driven gear or pump body.



4. INSPECT FRONT OIL PUMP DRIVE GEAR ROTATION


D027962E01
  1. Make sure the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter.