Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

The radio receiver assembly sends sound signals to the stereo component amplifier assembly through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.

WIRING DIAGRAM


E236073E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY- STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the E83 radio receiver assembly and K10 stereo component amplifier assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E83-9 (L+) - K10-3 (L+)
    Always
    Below 1 Ω
    E83-19 (L-) - K10-13 (L-)
    Always
    Below 1 Ω
    E83-8 (R+) - K10-4 (R+)
    Always
    Below 1 Ω
    E83-18 (R-) - K10-14 (R-)
    Always
    Below 1 Ω
    E83-9 (L+) - Body ground
    Always
    10 kΩ or higher
    E83-19 (L-) - Body ground
    Always
    10 kΩ or higher
    E83-8 (R+) - Body ground
    Always
    10 kΩ or higher
    E83-18 (R-) - Body ground
    Always
    10 kΩ or higher
    E83-10 (SLD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)