Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SPEEDOMETER
  1. Check speedometer operation.

    NOTICE:
    1. The meter ECU receives the vehicle speed signal from the skid control ECU via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU because it is the source of the vehicle speed signal.
    2. The Data List values of the skid control ECU are used for this inspection. Therefore, make sure to perform the inspection after confirming that no DTCs are output from the brake control system.
    3. If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform the inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.


    1. Before starting the following inspection, check if the Brake Control System outputs the DTCs.

    2. Check the values by referring to the table below.

      ABS/VSC/TRAC 
      Tester Display
      Measurement Item/Range
      Normal Condition
      Diagnostic Note
      Vehicle Speed
      Maximum wheel speed sensor reading/
      Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph)
      Vehicle stopped: 0 km/h (0 mph)
      When driving at constant speed: No large fluctuations

      Reference (Indicator Type: mph) 
      Techstream Indication (mph)
      Acceptable Range (mph)
      20
      19 to 21.5
      40
      39.1 to 41.9
      60
      59.3 to 62.1
      80
      79.3 to 82.5
      100
      99.5 to 102.7

      Reference (Indicator Type: km/h) 
      Techstream Indication (km/h)
      Acceptable Range (km/h)
      20
      18.2 to 22.2
      40
      38.3 to 42.8
      60
      58.5 to 63
      80
      78.4 to 83.4
      100
      98.6 to 103.6
      120
      118.9 to 123.9
      140
      139.1 to 144.1
      160
      159.3 to 164.3



2. INSPECT TACHOMETER
  1. Check the operation.

    1. Connect the Techstream, and start the engine.

    2. Compare the test results with the tachometer indications.

      Reference 
      Techstream Indication (rpm)
      Acceptable Range (rpm)
      Data in ( ) is for Reference
      700
      630 to 770
      1000
      (900 to 1100)
      2000
      (1850 to 2150)
      3000
      2800 to 3200
      4000
      (3800 to 4200)
      5000
      4800 to 5200
      6000
      (5750 to 6250)
      7000
      6700 to 7300