Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Clutch Switch Circuit

for Preparation Click here


DESCRIPTION

Clutch switch circuit inspection is necessary for M/T vehicles.
When the clutch pedal is released, the ECM receives the positive (+) battery voltage through the ECU-IG fuse and ignition switch. While the clutch pedal is depressed, the clutch switch assembly sends a signal to terminal D of the ECM. The ECM cancels cruise control when terminal D receives the signal (voltage of below 1 V).

WIRING DIAGRAM


B133355E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY)
  1. Disconnect the B47 ECM connector.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Clutch Pedal Condition
    Specified Condition
    D(B47-27) - Body ground
    Depressed
    Below 1 V
    D(B47-27) - Body ground
    Released
    11 to 14 V

  1. Reconnect the ECM connector.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT CLUTCH SWITCH ASSEMBLY


    I031382E04
  1. Disconnect the clutch switch connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Clutch Pedal Condition
    Specified Condition
    1 - 2
    Switch pin free
    (Clutch pedal depressed)
    10 kΩ or higher
    1 - 2
    Switch pin pushed in
    (Clutch pedal released)
    Below 1 Ω

  1. Reconnect the clutch switch connector.



NG
REPLACE CLUTCH SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (CLUTCH SWITCH ASSEMBLY - ECM)
  1. Disconnect the B47 ECM connector.

  1. Disconnect the A25 clutch switch connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A25-2 or D (B47-27) - Body ground
    10 kΩ or higher
    A25-2 - D (B47-27)
    Below 1 Ω

  1. Reconnect the clutch switch connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (CLUTCH SWITCH ASSEMBLY - ECM)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (CLUTCH SWITCH ASSEMBLY - BATTERY)