Home › BODY › INSTRUMENT PANEL › INSTRUMENT PANEL ASSEMBLY

INSTRUMENT PANEL ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
Use the same procedure for both the RH and LH sides.



1. BOLTS, SCREWS AND NUTS TABLE


HINT:
All bolts, screws and nuts relevant to installing and removing the instrument panel are shown, along with their alphabetic codes, in the table below.



B133850E01



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


3. REMOVE FRONT DOOR SCUFF PLATE RH


    B130597
  1. Disengage the 14 claws and remove the front door scuff plate.



4. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side.



5. REMOVE FRONT FLOOR FOOTREST


    B130586
  1. Disengage the 4 claws and remove the front floor footrest.



6. REMOVE FOOTREST CLIP


    B130587
  1. Remove the 2 footrest clips.



7. REMOVE COWL SIDE TRIM BOARD RH


    B130599
  1. Remove the clip.

  1. Disengage the 2 claws and remove the cowl side trim board.



8. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure as for the RH side.



9. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
  1. Separate the front door opening trim weatherstrip LH.



10. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
  1. Separate the front door opening trim weatherstrip RH.



11. REMOVE ASSIST GRIP PLUG


B175647E03

HINT:
Use the same procedure to remove all the assist grip plugs.

Text in Illustration 
*1
Protective Tape
*a
for RH Side
*b
for LH Side
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the assist grip plug.



12. REMOVE ASSIST GRIP ASSEMBLY


B175648E03

HINT:
Use the same procedure to remove all the assist grips.

Text in Illustration 
*a
for RH Side
*b
for LH Side
  1. Remove the 2 screws and the assist grip.



13. REMOVE FRONT PILLAR GARNISH RH


    B267110
  1. Disengage the 2 clips and the guide and remove the front pillar garnish.



14. REMOVE FRONT PILLAR GARNISH LH

HINT:
Use the same procedure as for the RH side.



15. REMOVE INSTRUMENT PANEL GARNISH LH


    B133886
  1. Remove screw <H>.

  1. Disengage the 3 clips and remove the instrument panel garnish.

    NOTICE:
    1. Pull the instrument panel garnish up at an angle of 45° to remove it.
    2. Do not damage the surface of the instrument panel when removing it.



16. REMOVE INSTRUMENT PANEL GARNISH RH


    B133887
  1. Remove screw <H>.

  1. Disengage the 3 clips and remove the instrument panel garnish.

    NOTICE:
    1. Pull the instrument panel garnish up at an angle of 45° to remove it.
    2. Do not damage the surface of the instrument panel when removing it.



17. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    B133888
  1. Remove the 2 <H> screws.

  1. Disengage the 4 clips and remove the integration control panel assembly.

  1. Disconnect the 3 connectors.



18. REMOVE RADIO RECEIVER ASSEMBLY


    E221529
  1. Remove the 4 bolts and the radio receiver.

  1. Disconnect the connectors.



19. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B133898E02
  1. Disengage the 2 A claws and 2 B claws.

  1. Slide the parking brake hole cover toward the front of the vehicle, disengage the 2 C claws and remove the parking brake hole cover.



20. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


    B133893
  1. Remove the shift lever knob.



21. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


    B133895
  1. Remove the shift lever knob.



22. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B133897
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and 3 claws and remove the console upper rear panel.



23. REMOVE BOX BOTTOM MAT


    B133899
  1. Remove the box bottom mat.



24. REMOVE FRONT CONSOLE BOX


    B133851
  1. Remove the 4 <D> bolts.

  1. Disengage the 5 claws and remove the console box.



25. REMOVE CONSOLE UPPER PANEL NO. 1 GARNISH


B133900E01
  1. Disengage claw A and the clip.

  1. Slide the console upper panel garnish toward the rear of the vehicle, disengage the claw B and remove the console upper panel garnish.



26. REMOVE INSTRUMENT LOWER COVER SUB-ASSEMBLY


    B133852
  1. Remove the 2 clips and 2 <F> bolts.

  1. Disengage the 3 clips and 2 claws and remove the instrument lower cover.



27. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B133853
  1. Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.



28. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B133859
  1. Disengage the 3 claws and separate the hood lock control lever.



29. REMOVE INSTRUMENT PANEL FINISH PLATE


E149562E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the instrument panel finish plate.



30. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B133860
  1. Remove the 2 <F> bolts.

  1. Disengage the 5 clips and claw and remove the lower instrument panel finish panel.

  1. Disconnect the connector.



31. REMOVE LOWER INSTRUMENT PANEL LH


    B133864
  1. Remove the 4 <F> bolts and remove the lower instrument panel.



32. REMOVE INSTRUMENT CLUSTER FINISH PANEL


    B133861
  1. Disengage the 3 clips and the 4 claws and remove the instrument cluster finish panel.

  1. Disconnect the connectors.



33. REMOVE COMBINATION METER ASSEMBLY


    B133862
  1. Remove the 4 screws.



    B133863
  1. Disconnect the 2 connectors and clamp and remove the combination meter.



34. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B133854E01
  1. Disengage the claw and separate the glove compartment door stoppers from the glove compartment door.

  1. Slightly flex the upper part of the glove compartment door assembly to release the 2 stoppers and open the glove compartment door until it becomes horizontal.



    B133855
  1. Pull the glove compartment door assembly toward the rear of the vehicle to release the 3 hinges and remove the glove compartment door assembly.



35. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH


    B133857
  1. Remove screw <A>.

  1. Disengage the 2 clips and claw and remove the instrument panel lower finish panel.

  1. Separate the connectors from the instrument panel lower finish panel.



36. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    B287551E01
  1. Apply protective tape, as shown in the illustration.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the instrument panel hole cover.



    B287549
  1. Remove the bolt <F> and clip.

  1. Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.



37. REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    B133865
  1. Disengage the 4 clips and claw and remove the instrument panel speaker panel.



38. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side.



39. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    E218763
  1. Disengage the clamp.

  1. Remove the 2 bolts and the front speaker bracket.



40. REMOVE ASSIST GRIP RETAINER RH


B133881
  1. Remove the 2 bolts and remove the assist grip retainer.



41. REMOVE ASSIST GRIP RETAINER LH

HINT:
Use the same procedure as for the RH side.



42. DISCONNECT PASSENGER AIRBAG CONNECTOR


B133890E02
  1. Slide the slider and disconnect the passenger airbag connector.



43. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. Disengage the clamps and disconnect the connectors.



  1. Remove the 2 <C> bolts, 2 <E> bolts, 7 <F> bolts and nut <G> and remove the instrument panel.


    B133866E01



44. REMOVE METER COVER


    B133867
  1. Disengage the 6 clips and remove the meter cover.



45. REMOVE ACCESSORY METER ASSEMBLY


    B133868
  1. Remove the 2 nuts and remove the accessory meter.



46. REMOVE NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY


    B133870
  1. Remove the 2 <H> screws.

  1. Disengage the 4 clips and 2 claws and remove the instrument panel box door.



47. REMOVE GLOVE COMPARTMENT DOOR STOPPER SUB-ASSEMBLY


    B133878
  1. Disengage the claw and remove the glove compartment door stopper.



48. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B133871
  1. Remove the 3 <B> screws.

  1. Disengage the 2 clips and 2 claws and remove the instrument cluster finish panel.



49. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY


    B133872
  1. Remove the 2 <B> screws.

  1. Disengage the 4 claws and remove the instrument cluster center finish panel.



50. REMOVE INSTRUMENT CLUSTER LOWER CENTER FINISH PANEL SUB-ASSEMBLY


    B133880
  1. Remove the 3 <B> screws.

  1. Disengage the 2 clips and 3 claws and remove the instrument cluster lower center finish panel.



51. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT


    B133874
  1. Remove screw <B>.

  1. Disengage the 2 claws and remove the side defroster nozzle duct.



52. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT


    B133873
  1. Remove screw <B>.

  1. Disengage the 2 claws and remove the side defroster nozzle duct.



53. REMOVE DEFROSTER NOZZLE ASSEMBLY


    B133875
  1. Remove the 5 <B> screws.

  1. Disengage the 9 claws and remove the defroster nozzle.



54. REMOVE NO. 3 HEATER TO REGISTER DUCT


    B133876
  1. Remove the 2 <B> screws and remove the heater to register duct.



55. REMOVE NO. 2 INSTRUMENT PANEL WIRE


  1. Disengage the 16 clamps and remove the instrument panel wire.


    B133892



56. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    C128213
  1. Remove the 2 screws.



    C128214E01
  1. Using a screwdriver (with its tip wrapped in protective tape), disengage the 5 hooks from the instrument panel and turn the front passenger airbag assembly in the direction indicated by the arrow shown in the illustration.

  1. Disengage the 5 hooks and remove the front passenger airbag assembly from the instrument panel.



57. REMOVE INSTRUMENT PANEL CENTER BRACKET SUB-ASSEMBLY


    B133877
  1. Remove the 2 <B> screws and remove the instrument panel center bracket.



58. REMOVE ACCESSORY METER BRACKET


    B133882
  1. Remove the 2 clips and remove the accessory meter bracket.



59. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY RH


    B133879
  1. Disengage the 2 clips and remove the lower instrument panel.



60. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY LH

HINT:
Use the same procedure as for the RH side.



61. REMOVE INSTRUMENT PANEL FINISH PANEL END LH


    B133889
  1. Disengage the 3 claws and remove the instrument panel finish panel end.