Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY


G021673E01
  1. Fully extend the shock absorber piston rod, and fix it at an angle in a vise or similar tool.

  1. Using a drill or similar tool, slowly make a hole at approximately 50 mm (1.97 in.) from the top end of the shock absorber, and discharge the gas inside.

    CAUTION:
    1. The gas is colorless, odorless and harmless.
    2. Since the discharged gas may cause chips to scatter, cover the drill with a shop rag or piece of cloth when making the hole.