Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEELS


2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY


3. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH


C099158
  1. Remove the nut and separate the front stabilizer link assembly LH from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



4. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



5. REMOVE FRONT STABILIZER BAR


G020162
  1. Remove the 4 bolts and 2 stabilizer brackets and remove the stabilizer bar.



6. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and nut.



    F051679E01
  1. Using SST, separate the tie rod end from the steering knuckle.

    SST
    09628-62011  



7. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


C099159
  1. Remove the bolt, nut and the washer on the lower side of the front shock absorber with coil spring.



    C099160
  1. Remove the 3 nuts on the upper side of the front shock absorber with coil spring.

  1. Remove the front shock absorber with coil spring.



8. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


    C099161E01
  1. Secure SST in a vise.

    SST
    09727-00060  
    09727-30021   (09727-00010, 09727-00031)



    C263591
  1. Attach the arm of SST to the diameter of the front coil spring.

    CAUTION:
    1. Make sure that the front coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
    2. Make sure that the claws of the hooks are securely attached.

  1. Using SST, compress the front coil spring.

    CAUTION:
    1. If the front coil spring bends during the compression, immediately stop the compression and reinstall SST.
    2. Do not compress the spring until the coil springs contact each other.
    3. Do not use an impact wrench. It will damage SST.



    C099162
  1. Confirm that the front coil spring becomes free and while holding the shock absorber rod, remove the front support to front shock absorber nut.

    CAUTION:
    Do not remove the front support to front shock absorber nut when the front coil spring is not free.



9. REMOVE FRONT SHOCK ABSORBER CUSHION RETAINER


10. REMOVE FRONT SHOCK ABSORBER NO. 1 CUSHION


11. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY


12. REMOVE FRONT SHOCK ABSORBER CUSHION RETAINER


13. REMOVE FRONT COIL SPRING


14. REMOVE FRONT SHOCK ABSORBER BUSH


    C099164E01
  1. Using SST and a press, remove the front shock absorber bush.

    SST
    09710-22021   (09710-01071, 09710-01081)