Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM

FRONT UPPER SUSPENSION ARM > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. INSPECT FRONT UPPER SUSPENSION ARM
  1. Check that there is no slack on the ball joint by shaking the upper arm up and down by hand.



3. SEPARATE SKID CONTROL SENSOR WIRE


C099168
  1. Remove the 2 bolts and separate the skid control sensor wire.



4. REMOVE FRONT UPPER SUSPENSION ARM
  1. Support the lower arm with a jack.

  1. Remove the clip and nut.



    G020151E01
  1. Using SST, separate the upper ball joint from the steering knuckle.

    SST
    09628-62011  



    G020152
  1. Remove the bolt and separate the bracket.



    G020153
  1. Remove the bolt, 2 washers and nut.

  1. Remove the upper arm.