Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEELS


2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY


3. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


G020161
  1. Remove the 2 nuts and stabilizer link.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



4. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



5. REMOVE FRONT STABILIZER BAR


G020162
  1. Remove the 4 bolts and 2 stabilizer brackets and remove the stabilizer bar.



6. REMOVE FRONT STABILIZER BAR NO. 1 BUSH
  1. Remove the 2 stabilizer bar bushes from the stabilizer bar.