Home › DRIVE LINE ยท DRIVE SHAFT › FRONT DRIVE SHAFT ASSEMBLY

FRONT DRIVE SHAFT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT WHEEL


3. DRAIN DIFFERENTIAL OIL


4. SEPARATE FRONT SPEED SENSOR


C235318
  1. Remove the bolt and separate the front speed sensor.

  1. Disengage the clamp.

  1. Remove the 2 bolts and separate the skid control sensor wire from the steering knuckle.



5. REMOVE FRONT AXLE HUB GREASE CAP


F042729
  1. Using a screwdriver and a hammer, remove the front axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.



6. REMOVE FRONT AXLE HUB NUT


F042732
  1. Remove the cotter pin and adjusting lock cap.

  1. Remove the front axle hub nut.



7. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and nut.



    F051679E01
  1. Using SST, separate the tie rod end from the steering knuckle.

    SST
    09628-62011  



8. SEPARATE FRONT LOWER BALL JOINT ATTACHMENT


G020159
  1. Remove the 2 bolts and separate the front lower ball joint attachment from the steering knuckle.



9. REMOVE FRONT DRIVE SHAFT


F042739E01
  1. Using SST, remove the front drive shaft.

    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    Do not damage the oil seal.