Home › DRIVE LINE ยท DRIVE SHAFT › FRONT DRIVE SHAFT ASSEMBLY

FRONT DRIVE SHAFT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. INSPECT FRONT DRIVE SHAFT


W001721
  1. Check that there is no excessive play in the outboard joint.

  1. Check that the inboard joint slides smoothly in the thrust direction.

  1. Check that there is no excessive play in the radial direction of the inboard joint.

  1. Check the boots for damage.

    NOTICE:
    Move the drive shaft while keeping it level.



2. REMOVE FRONT AXLE INBOARD JOINT BOOT NO. 2 CLAMP


C108564
  1. Hold the drive shaft lightly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using pliers, remove the boot clamp as shown in the illustration.



3. REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP
  1. Remove the front axle inboard joint boot clamp.

    HINT:
    Perform the same procedures described for the front axle inboard joint boot No. 2 clamp.



4. SEPARATE INBOARD JOINT BOOT


C177089
  1. Separate the inboard joint boot from the inboard joint.



5. REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY
  1. Remove the old grease from the inboard joint.



    FA01615E09
  1. Place matchmarks on the inboard joint and outboard joint shaft.
    Text in Illustration 
    *a
    Matchmarks

    NOTICE:
    Do not punch the marks.

  1. Remove the inboard joint from the outboard joint shaft.

  1. Fix the outboard joint shaft in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.



    G022501
  1. Using a snap ring expander, remove the snap ring.



    C183637E01
  1. Place matchmarks on the outboard joint shaft and tripod.
    Text in Illustration 
    *1
    Brass bar
    *a
    Matchmarks

    NOTICE:
    Do not punch the marks.

  1. Using a brass bar and hammer, remove the tripod from the outboard joint shaft.

    NOTICE:
    Do not tap the roller.

  1. Remove the inboard joint boot No. 2 clamp, the inboard joint boot and the inboard joint boot clamp.



6. REMOVE FRONT DRIVE INNER SHAFT INNER SHAFT SNAP RING


C057543
  1. Using a screwdriver, remove the snap ring.



7. REMOVE FRONT DRIVE SHAFT DUST COVER


C175797E01
  1. Using SST and a press, remove the dust cover.

    SST
    09950-00020  



8. REMOVE FRONT AXLE OUTBOARD JOINT BOOT NO. 2 CLAMP


  1. for one-touch clamp type



      C234463
    1. Using a screwdriver, release the staked part of the boot clamp and remove the boot clamp.



  1. for omega clamp type



      C234464
    1. Using pliers, remove the boot clamp as shown in the illustration.



9. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP


C081566
  1. Using pliers, remove the boot clamp, as shown in the illustration.



10. REMOVE OUTBOARD JOINT BOOT


C234466
  1. Remove the outboard joint boot from the outboard joint shaft.

  1. Remove the old grease from the outboard joint.