Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT WHEEL


3. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with painted surfaces.



4. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY


F042731
  1. Remove the bolt and separate the brake tube bracket from the steering knuckle.



    C168980
  1. Using a union nut wrench, separate the brake tube from the front disc brake caliper assembly.

    HINT:
    Use a container to collect the brake fluid as it drains out.



    F050211
  1. Remove the 2 bolts and front disc brake caliper assembly.



5. REMOVE FRONT DISC
  1. Place matchmarks on the disc and the axle hub and remove the disc.



6. SEPARATE FRONT SPEED SENSOR


C235318
  1. Remove the bolt and separate the front speed sensor.

  1. Disengage the clamp.

  1. Remove the 2 bolts and separate the skid control sensor wire from the steering knuckle.



7. REMOVE FRONT AXLE HUB GREASE CAP (for 4WD)


F042729
  1. Using a screwdriver and a hammer, remove the front axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.



8. REMOVE FRONT AXLE HUB NUT (for 4WD)


F042732
  1. Remove the cotter pin and adjusting lock cap.

  1. Remove the front axle hub nut.



9. SEPARATE FRONT STABILIZER LINK ASSEMBLY


C099158
  1. Remove the nut and separate the front stabilizer link assembly LH from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



10. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and nut.



    F051679E01
  1. Using SST, separate the tie rod end from the steering knuckle.

    SST
    09628-62011  



11. SEPARATE FRONT LOWER BALL JOINT ATTACHMENT


G020159
  1. Remove the 2 bolts and separate the front lower ball joint attachment from the steering knuckle.



12. SEPARATE FRONT UPPER SUSPENSION ARM
  1. Support the lower arm with a jack.

  1. Remove the clip and nut.



    G020151E01
  1. Using SST, separate the upper ball joint from the steering knuckle.

    SST
    09628-62011  



13. REMOVE FRONT AXLE ASSEMBLY
  1. for 4WD:

    1. Using a plastic hammer, separate the front axle hub from the front drive shaft.

  1. Remove the front axle assembly.