Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 2 SKID CONTROL SENSOR CLAMP


C235320
  1. Remove the bolt and the No. 2 skid control sensor clamp from the steering knuckle.



2. REMOVE KNUCKLE GREASE RETAINER CAP (for 2WD)


F042756
  1. Using a screwdriver and hammer, remove the retainer cap.



3. REMOVE STEERING KNUCKLE OIL SEAL (for 4WD)


F042766
  1. Using a screwdriver and hammer, remove the oil seal.



4. REMOVE FRONT AXLE HUB


F042759
  1. Remove the 4 bolts, axle hub and dust cover from the steering knuckle.

  1. Remove the O-ring from the axle hub.



5. REMOVE FRONT WHEEL ADJUSTING NUT (for 2WD)


F042757E01
  1. Using SST and a hammer, unstake the adjusting nut.

    SST
    09930-00010  



    C119748E01
  1. Using SST, remove the front wheel adjusting nut.

    SST
    09318-12010  



6. REMOVE FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY


F042760E02
  1. Gently fix the front axle hub in a vise.

  1. Using SST, remove the bearing.

    SST
    09710-30021   (09710-03051)
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)



7. REMOVE FRONT AXLE HUB OIL SEAL


F042761
  1. Using a screwdriver, remove the oil seal.



8. REMOVE PLUG (for 2WD)


C221065
  1. Using a screwdriver and hammer, remove the plug.