Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > REASSEMBLY

for Preparation Click here



1. INSTALL PLUG (for 2WD)


C119749E01
  1. Using the SST and a hammer, install a new plug.

    SST
    09950-60010   (09951-00450)
    09950-70010   (09951-07100)



2. INSTALL FRONT AXLE HUB OIL SEAL


C235699E01
  1. Using SST and a hammer, install a new oil seal.

    SST
    09608-36010  
    09950-70010   (09951-07100)



3. INSTALL FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY


C098702E01
  1. Using SST and a press, install a new bearing onto the axle hub.

    SST
    09649-17010  



4. INSTALL FRONT WHEEL ADJUSTING NUT (for 2WD)


C119748E01
  1. Using SST, install a new adjusting nut.

    SST
    09318-12010  

    Torque:
    275 N*m{ 2,804 kgf*cm , 203 ft.*lbf }



5. INSTALL FRONT AXLE HUB
  1. Apply MP grease to a new O-ring.

  1. Install the new O-ring onto the axle hub.



    F042759
  1. Install the dust cover and axle hub onto the steering knuckle with the 4 bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



6. INSTALL KNUCKLE GREASE RETAINER CAP (for 2WD)


F042765
  1. Using a brass bar and a hammer, install a new retainer cap.

    NOTICE:
    Do not damage the retainer cap.



7. INSTALL STEERING KNUCKLE OIL SEAL (for 4WD)


F042767E02
  1. Using SST and a press, install a new oil seal.

    SST
    09527-17011  
    09950-70010   (09951-07100)
    09951-01000  



8. INSTALL NO. 2 SKID CONTROL SENSOR CLAMP


C235320
  1. Install the No. 2 skid control sensor clamp onto the steering knuckle with the bolt.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }