FRONT AXLE HUB BOLT > INSTALLATION |
| 1. INSTALL FRONT AXLE HUB BOLT |
![]() |
Install the washer and the nut onto a new hub bolt, as shown in the illustration.
Using a screwdriver or the equivalent to hold the axle hub, install the hub bolt by tightening the nut.
| 2. INSTALL FRONT DISC |
Align the matchmarks of the disc and axle hub and install the disc.
| 3. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the front disc brake caliper assembly with the 2 bolts.
![]() |
Install the brake tube bracket onto the steering knuckle with the bolt.
![]() |
Using a union nut wrench, install the brake tube onto the front disc brake caliper assembly.
| *a | Fulcrum Length |
| 4. INSTALL FRONT WHEEL |
| 5. BLEED BRAKE LINE |
Turn the ignition switch on (IG).
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.
Repeatedly depress the brake pedal and bleed air from the bleeder plug of the front disc brake cylinder RH.
Repeat the step above until the air is completely bled, and then tighten the bleeder plug while depressing the brake pedal.
Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.
With the brake pedal depressed, loosen the bleeder plug of the rear disc brake cylinder RH, continue to hold the brake pedal and allow brake fluid to be drained from the bleeder plug while the pump motor operates.
When there is no more air in the brake fluid, tighten the bleeder plug, and then release the brake pedal.
Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.
Turn the ignition switch off (IG).
Inspect for brake fluid leaks.
Check and adjust the brake fluid level .
| 6. CHECK FOR BRAKE FLUID LEAKAGE |